collapse
« previous next »
Pages: [1]

Author Topic: Hall Xtra faceting machine speed controller.  (Read 4127 times)

rusty46

  • ALF'er Bronze Member
  • *
  • Posts: 5
Hall Xtra faceting machine speed controller.
« on: July 27, 2020, 11:00:49 AM »
I have been using my recently purchased Hall Xtra (may be 5 years old) for all of one week now. Yesterdays switchon gave me full speed only on the lap. A look inside the control speed assembly compartment leads to my question. Do I need a complete circuit board or can I obtain the control assembly and install it with what appears to be 3 solder points only? Any info would be appreciated thanks.
Logged
Pages: [1]
« previous next »
 

Recent Activities

Magnetic Encoders by Faceting Frank
[May 21, 2025, 08:39:33 PM]
Valuing your faceted stone collection by Bucket
[May 21, 2025, 09:30:21 AM]
Cat's Eye Facet Design by RoughCreations
[May 12, 2025, 09:29:44 AM]
Cutting the table by Faceting Frank
[May 06, 2025, 08:21:00 AM]
Mt Strzelecki on Flinders Island by Bucket
[April 30, 2025, 05:45:40 PM]
Fossicking trip by Barry Simiana
[April 09, 2025, 03:51:18 PM]
Butterfly cut by MakkyBrown
[March 29, 2025, 03:42:54 PM]
Pendant findings by Faceting Frank
[March 18, 2025, 12:38:24 PM]
Topaz scratches (aka should've known better) by RoughCreations
[March 15, 2025, 07:00:56 AM]
Resin-bonded 60K diamond lap by RoughCreations
[March 13, 2025, 08:22:58 AM]
Has anyone modified a gemmasta to take a dial gauge on the hard stop? by Rusted
[March 05, 2025, 11:01:12 AM]
Faceting machine encoder by Faceting Frank
[February 24, 2025, 05:16:07 PM]
The Art of Moissanite Cutting: Transforming Rough Stones into Brilliance by MakkyBrown
[February 24, 2025, 02:59:58 PM]
AgateMaster Faceting Machine Bearing Replacement by Bucket
[February 16, 2025, 09:11:49 AM]
Anyone Faceted Synthetic Rutile Gem rough? Any Advice. by RoughCreations
[February 14, 2025, 10:46:42 AM]
SimplePortal 2.3.7 © 2008-2025, SimplePortal